Type H-110
Two-point vertical Slam Type Latch


Recommended for standard height and extremely fall doors requiring automatic, positive high strength bolting action with latching pressure at the head and sill. Can be installed on either hinge side or stop side. Also used on the inactive leaf of double doors with the Adhaco H-120 System installed on active lead of double-door. (Refer to Page HL 1). Standard fasteners included are hex head cap screws. Features include positive retraction and retention of latch bolts when the door is open; prevents dragging and floor damage automatic latching when the door is closed. Adjustable linkage rods, attractive cast handle with safety torque return spring. Corrosion resistant, high strength malleable iron castings rugged 1 ¼ cold rolled steel bolts, standard finish U.S. Prime, other finishes available.  Standard weight 60 lbs. minimum.

Specifications

Latch hardware will be Adhaco H-110 Two Point Vertical Slam Latch, positive acting.  Adjustable, vibration-proof and pressure exerting. Latching will be two 1/4 “ diameter cold rolled street bolts interconnected by adjustable control rods to be cast malleable operating handy. Movement of operating handle simultaneously retracts latch bolts. Bolts shall be retained in the retracted position until the door is slammed closed allowing the latch bolts to automatically engage the strikes. Spring-back of the operating handle shall be prevented by a concealed safety torque return spring.

Options Available
Manual Operations
Stop side operation only
Paired door interlock (when used on pairs with H-120 System, Locks H-110 Handle until active leaf is opened).
Bottom keeper same as top strike for installation in poured concrete floor (flush)
Cadmium or Chrome Finish
Extra heavy duty springs and rod guides (recommended for doors over 12’ high)

Sizes
Standard – all sizes up to 12’-0” high.
Special – All doors more than 12’-0” high and/or latches requiring optional features.




Ordering Information Required

Hand of Door
Frame opening height
Consult factory or representative when options are needed.